Publication

TOP

Publication

112

Development of cutoff size adjustable omnidirectional inlet cyclone separator

Separation and Purification Technology 276: 119397

111

Heat-dissipation performance of cylindrical heat sink with perforated fins

International Journal of Thermal Sciences 170: 107132

110

Analysis of the aspiration ratio of double-shrouded probes according to angle of attack and probe scale

Aerosol Science and Technology 55: 1202-1213

109

Magneto-free-convection flow of a rate type fluid over an inclined plate with heat and mass flux

Case Studies in Thermal Engineering 27: 101249

108

Insight into the dynamics of time-dependent cross nanofluid on a melting surface subject to cubic autocatalysis

Case Studies in Thermal Engineering 27: 101227

107

Gear-generalized differential quadrature analysis of oscillatory convective Taylor-Couette flows of second-grade fluids subject to Lorentz and Darcy-Forchheimer quadratic drag forces

International Communications in Heat and Mass Transfer 126: 105395

106

An accurate approach for thermal analysis of porous longitudinal, spine and radial fins with all nonlinearity effects analytical and unified assessment

Applied Mathematics and Computation 402: 126124

105

Deposition characteristics of soot and tire-wear particles on urban tree leaves

Journal of Aerosol Science 155: 105768

104

Effect of a system air conditioner on local air quality in a four-bed ward

Aerosol and Air Quality Research 21: 200533

103

Performance improvement of a horizontal zigzag type mist eliminator by using slit plates

Journal of Mechanical Science and Technology 35: 2229-2236

102

Required flux tower height for measurement of re-suspended road dust

Journal of Mechanical Science and Technology 35: 1781-1789

101

Optimization of pipe-and-spike discharge electrode shape for improving electrostatic precipitator collection efficiency

Powder Technology 379: 241-250

100

Three-dimensional thermal assessment in cancerous tumors based on local thermal non-equilibrium approach for hyperthermia treatment

International Journal of Thermal Sciences 159: 106591

99

Numerical investigation of bus stop structures in Seoul for the reduction of fine dust entry

Journal of Mechanical Science and Technology 35: 371-379

98

Performance investigation of a vertical wave-plate mist eliminator with perforated plates

Aerosol and Air Quality Research 20: 2681-2689

97

Aspiration ratio of a double-shrouded probe under low pressure conditions in troposphere

Aerosol Science and Technology 54: 1323-1334

96

Effects of exponentially decaying and growing concentrations on particle size distribution from a scanning mobility particle sizer

Aerosol Science and Technology 54: 1135-1143

95

Development of a multi-slit virtual impactor as a high-volume bio-aerosol sampler

Separation and Purification Technology 250: 117275

94

Effect of a protective shape upstream a sensor on reducing dust particle contamination of critical sensor surface

Sensors and Actuators A 312: 112126

93

Characteristics of dust-collection efficiency and ozone emission by high-voltage electrode shape of electrostatic precipitator for subway tunnel environment

Journal of Mechanical Science and Technology 34: 1351-1363