Publication

TOP

Publication

72

Inverse heat conduction modeling to predict heat flux in a hollow cylindrical tube having irregular cross-sections

Applied Thermal Engineering 128: 1310-1321

71

Enhancement of collection efficiency of an inertial impactor using an additional punched impaction plate

Aerosol and Air Quality Research 17: 2349-2357

70

Performance estimation of a louver dust collector attached to the bottom of a subway train running in a tunnel

Aerosol and Air Quality Research 17: 1954-1962

69

Cooling performance of a radial heat sink with triangular fins on a circular base at various installation angles

International Journal of Thermal Sciences 120: 377-385

68

Comparison of black carbon concentration and particle mass concentration with elemental carbon concentration for multi-walled carbon nanotube emission assessment purpose

Carbon 122: 228-236

67

Fine particle emission characteristics of a light-duty diesel vehicle according to vehicle acceleration and road grade

Transportation Research Part D 53: 428-439

66

Three-dimensional inverse heat conduction modeling of a multi-layered hollow cylindrical tube using input estimation algorithm and thermal resistance network

International Journal of Heat and Mass Transfer 106: 793-803

65

Overestimation of on-road air quality surveying data measured with a mobile laboratory caused by exhaust plumes of a vehicle ahead in dense traffic areas

Environmental Pollution 218: 1116-1127

64

Investigation of airflow and particle behavior around a subway train running in the underground tunnel

Aerosol Science and Technology 50: 669-678

63

Evaluation of clean air delivery rates and operating cost effectiveness for room air cleaner and ventilation system in a small lecture room

Energy and Buildings 119: 111-118

62

Prediction of time-varying heat flux along a hollow cylindrical tube wall using recursive input estimation algorithm and thermal resistance network method

International Journal of Heat and Mass Transfer 97: 232-241

61

Effect of air-gap fans on cooling of windings in a large-capacity, high-speed induction motor

Applied Thermal Engineering 100: 658-667

60

Optimization of a chimney design for cooling efficiency of a radial heat sink in a LED downlight

Energy Conversion and Management 114: 180-187

59

Local behavior of deposition velocity onto a flat plate in horizontal airflow under the influence of thermophoresis

Aerosol Science and Technology 49: 920-927

58

Development of a single cyclone separator with three stages for size-selective sampling of particles

Journal of Aerosol Science 89: 18-25

57

Investigation of particulate contamination of heated wafers contained in a closed environment

Journal of Aerosol Science 88: 148-158

56

Inverse heat transfer analysis of multi-layered tube using thermal resistance network and Kalman filter

International Journal of Heat and Mass Transfer 89: 1016-1023

55

Optimization of a staggered pin-fin for a radial heat sink under free convection

International Journal of Heat and Mass Transfer 87: 184-188

54

Investigation of collection efficiency of round-nozzle impactors at different atmospheric pressures and temperatures

Advanced Powder Technology 26: 868-873

53

Workplace exposure to titanium dioxide nanopowder released from a bag filter system

BioMed Research International 2015: 524283